Woodstock W1811 - Manual (Page 19)

-17-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
Kfi\dfm\k_\kXYc\jXn]ifdk_\ZiXk\gXcc\k#[f
k_\j\jk\gj1
(% Feed the lifting straps around the lifting bolts on the
back of the table and the sliding table saw mounts
on the front of the cabinet (see
=`^li\((). Attach
the ends of the lifting straps to the forklift forks.
)% Lift the table saw cabinet and move it to your pre-
determined location.
*% Remove the red lifting bolts from the back of the
table.
C`]k`e^ Dfm`e^
K_`j dXZ_`e\ n\`^_j fm\i ,'' cYj%
J\i`flj g\ijfeXc `ealip dXp fZZli `]
jX]\dfm`e^d\k_f[jXi\efk]fccfn\[%
Kf Y\ jX]\# pfl n`cc e\\[ Xk c\Xjk fe\
fk_\ig\ijfeXe[X]fibc`]kkfdfm\Xe[
gcXZ\k_`jdXZ_`e\%
Lj\c`]k`e^jkiXgjn`k_Xd`e`dldc`]k`e^
ZXgXZ`kp _`^_\i k_Xe k_\ jXn n\`^_k%
;F EFK c`]k jXn _`^_\i k_Xe e\Z\jjXip
kf Zc\Xi ]cffi% @] c`]k`e^ jkiXg Yi\Xbj#
j\i`fljg\ijfeXc`ealipdXpfZZli%
=`^li\((% Lifting the table saw.
=`^li\()% Hex bolt in stand corners for
leveling; the hex nut is used to secure the
bolt position.
+% Place a level on the cast iron table to level the table
saw cabinet side-to-side and front-to-back. This will
allow the table to slide smoothly.
Efk\1 K_\i\Xi\knffgk`fej]fic\m\c`e^k_\jXn1
( J_`dle[\ik_\ZXY`e\k#fi) k_i\X[Yfckj[fne
`ekfk_\elkjn\c[\[fek_\jkXe[Zfie\ij =`^li\
() %