Woodstock W1737 - Manual (Page 19)

-17-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
O
PE
R
ATIO
NS
General Operation
Test Run
Once assembly is complete, the machine is ready for
a test run. The purpose of a test run is to identify any
unusual noises and vibrations, as well as to confirm that
the machine is performing as intended.
To complete the test run, do these steps:
1. Tie back loose clothing and hair, and wear a
respirator and safety glasses.
2. Make sure all access doors and handles are secured.
3. Start the dust collection system.
4. Connect power to the sander and connect the supply
air to the sander. Make sure the air pressure is set
at 70 PSI.
5. Turn the sander and feed belt ON .
6. Listen for any unusual noises. A slow, rhythmic air
hiss is normal. The machine should run smoothly
with little or no vibrations.
—If there are any unusual noises or vibrations, shut
the machine OFF immediately. TURN OFF and
LOCK the master power switch so power cannot
go to your sander, and disconnect the air line.
Investigate the source of the noise or vibration. DO
NOT make any adjustments to the machine while it
is plugged in. The machine should not be run any
further until the problems are corrected.
Your sander will perform many types of operations that are
beyond the scope of this manual. If performed incorrectly,
many of these operations can be dangerous or deadly.
The instructions in this section are written with the under-
standing that the operator has the necessary knowledge
and skills to operate this machine. If at any time you are
experiencing difficulties performing any operation, or
you are inexperienced with this machine, stop using
the machine and consult your supervisor for help!
If you are an inexperienced operator, we strongly recom-
mend that you read books, trade articles, or seek training
from an experienced wide belt sander operator before
performing any unfamiliar operations. Above all, your
safety should come first!
REMEMBER, this machine produces fine
sawdust particles that can be inhaled,
causing allergic reactions or respiratory
problems. ALWAYS wear your respirator
in addition to using an adequate dust
collection system that draws at least
1500 CFM.