Tuner, Optional components – Sony CMT-EX5 User Manual

Page 24

Advertising
background image

24

GB

Tuner

There is severe hum or noise (“TUNED” or
“STEREO” flashes).

• Set the proper band and frequency (see page 13).

• Connect the antenna properly (see page 7).

• Find a place and an orientation that provide good

reception, then set up the antenna again.
If you cannot obtain good reception, we
recommend you connect a commercially
available external antenna.

• The supplied FM wire antenna receives signals

along its entire length, so make sure you extend
it fully.

• Locate the antennas as far away from the speaker

cords as possible.

• Consult your nearest Sony dealer if the supplied

AM antenna wire has come off the plastic stand.

• Try turning off surrounding electrical equipment.

A stereo FM program cannot be received in
stereo.

• Press FM MODE on the remote until “MONO”

disappears.

• See “There is severe hum or noise (“TUNED” or

“STEREO” flashes).”, and check the antenna
condition.

Optional components

There is no sound.

• Refer to General item “There is no sound.” on

page 23 and check the condition of the system.

• Connect the component properly (see page 21)

while checking:

– if the cords are connected properly.

– if the cord plugs are firmly inserted all the way.

• Turn on the connected component.

• Refer to the operating instructions included with

the connected component and start playing.

• Press FUNCTION repeatedly until “PC” (or

“MD” or “TAPE”) appears.

The sound is distorted.

• Set the volume of the connected component

lower.

• The external input may be excessively large. Set

the external function to “MD” (see page 22).

If the system still does not operate

properly after performing the above

measures, reset the system as

follows:

With the system turned on, press

Z

, TUNER/

BAND and FUNCTION at the same time.

“COLD RESET” appears and the system turns
off. The system is reset to the factory settings.
All the settings you made are cleared. Be sure
to restore all necessary settings.

Note

You cannot reset the system in the Power Saving
Mode.

Problems and remedies (continued)

Advertising