Dvr4400 dvd+vcr – Sonic Blue DVR4400 User Manual
Page 56
50
DVR4400 DVD+VCR
Auto Setup did not find all
channels.
• If a cable box is connected, the DVD+VCR will only find the cable box output channel. Use the alternative
cable box hookup.
No audio when playing VHS
tapes.
• You may be watching video from the S-Video or Component video output. Use the RF or Line connection to
play VHS tapes.
No picture.
• Press TV/VCR until the VCR indicator lights on the front panel display.
• Set RF Output to channel 4; see page 17.
Poor picture quality on VCR.
• Set RF Output to channel 4; see page 17.
• Adjust tracking with AUTO and TRK -/+ keys.
• Clean video heads with nonabrasive head cleaning tape.
Remote not working.
• Remove all obstacles and point directly at DVD+VCR.
• Make sure batteries are fresh and properly installed.
• Press DVD or VCR key. If you press DVD key, remote will only operate the DVD deck. If you press VCR
key, remote will only operate the VCR deck.
On-screen display shows Error.
• Turn power off, then turn power on again.
• Inspect tape/disc slots for foreign objects.
DVD+VCR doesn’t work.
• Unplug DVD+VCR for 10 seconds, then plug it in again.
• If it still doesn’t work, unplug overnight (at least 6 hours), then plug it in again. If the clock is still set, you
haven’t unplugged it long enough.
• If it still doesn’t work, DVD+VCR must be serviced by an authorized service center.
Cannot record from cable box.
• Set DVD+VCR to cable box output channel 2, 3 or 4, then select desired channel on cable box.
Cannot Timer Record.
• Set clock to correct time.
Tape ejects during copy or
record.
• Use tape with record safety tab.
• Place adhesive tape over record safety tab opening.
VCR automatically plays and
rewinds.
• Auto Play/Rewind is enabled. To turn off; see page 18.
Tape counters not moving on
VCR deck.
• To display tape counters, the VCR deck requires control track, which is only present on prerecorded tapes.
No menu or on-screen displays.
• Tape may be blank (snow appears on screen). If so, menus and on-screen display cannot be shown. Stop tape
or record on tape to enable displays.