Siemens GIGASET A58H - Manual (Page 10)

9
First steps
A58H / IM1 en / A31008-M2055-R101-2-4N19 / starting.fm / 01.08.2008
Ve
rs
ion 4,
29
.10.
2007
On the handset:
§Menu§
¢
Settings
¢
Handset
¢
Register Handset
(If you require further information on the illustration of these operating steps,
please see
¢
page 17.)
~ Enter the system PIN of the base station (the default is 0000) and
press §OK§ .
On the base station:
Within 60 sec. press and hold the registration/paging key on the base station
(approx. 3 sec.).
The following is displayed after successful automatic or manual handset
registration:
The handset is assigned the lowest unassigned internal number (1–4). If more
than one handset is registered to the base station, the internal handset number
appears on the display, e.g. INT 2 . If the internal numbers 1–4 are already
assigned to other devices, the number 4 will be overwritten.
To charge the batteries, leave the handset in the base station/charging cradle.
Should you have any questions and problems
¢
page 26.
Handset is
registering
ë
The registration screen is displayed.
Ð V
Þ
Menu
u the strength of the reception signal between
base station and handset:
– good to poor:
Ð i С Т
– no reception: | flashes
u battery charge status:
–
= e V U (flat to full)
– = flashes: batteries almost flat
– e V U flashes: charging procedure
Please note
Only place the handset in the base station or charging cradle that is
intended for it.