Siemens A30853 - Manual (Page 22)

Outgoing and incoming calls
14
kap01.fm5 27.11.98 Profiset 30isdn engl.: A30853-X300-B107-1-7619
Call list
If a caller does not reach you or if a caller or a queued
caller is rejected, the relevant call number (if it is known)
is stored in the call list.
Up to 12 different call numbers can be stored. The
number of retries of the same call number are also count-
ed and displayed. The most recent entry is displayed first.
Retrieving entries from the call list
Dialling a number from the call list
Call numbers which are stored in the call list can be dialled
as follows:
Storing a number from the call list
Numbers from the call list can be programmed on a
Destination dialling key or Speed dialling key.
j
The most recent entry of the call list is displayed by press-
ing the Call list key. Press the Call list key again to view
the previous entries.
h
If you press the Disconnect key the display of the call list
will disappear.
j
Press the Call list key until the desired call number
appears on the display.
c and d Lift the handset and talk.
If the connection to the party in the call list has been set
up and answered, the entry is deleted from the call list.
j Select the number via the Call list key.
S10
Start the programming procedure.
z Press the Destination dialling key.
S
Save the setting.
or
S11
Start the programming procedure.
T
Press the relevant digit key.
S Save the setting.
You can cancel a programming procedure
without making any changes by pressing the
Disconnect key h !