SMC Networks 100 - Manual (Page 47)

I
NSTALLING THE
S
WITCH
3-9
Connecting to a Power Source
To connect a device to a power source:
Note: It is recommended that the switches be stacked before
being connected to a power source. However, a device can
be added to the top or bottom of a stack that is on and
operating without first powering down the stack. Be sure to
stack the new device before connecting it to a power
source. All switches in a stack must be powered on to allow
traffic to pass across the stack’s backplane.
To connect each device to a power source:
1. Insert the power cable plug directly into the receptacle located
at the back of the device.
Figure 3-6. Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line
cord. You must use a line cord set that has been approved
for the receptacle type in your country.