Sony RM-LG112 - Manual (Page 12)

masterpage:Left
filename[\\B-02w2000e\SONY RM-LG112\4247243111\424724311RMLG112U\GB04ADV_RM-
LG112-U.fm]
12 GB
model name1[RM-LG112]
[4-247-243-11(1)]
By using the Learning function, it is possible for
this remote to perform learned commands.
Setting remote control codes
that are not stored in the
remote
When a remote control code is not one of the
presets stored in the remote, it is possible for the
remote to learn the code using the Learning
function.
1
Press TV ?/1 while holding down USE
MODE.
The USE MODE button lights and
“LEARN” appears in the display.
2
Move the easy scroll key to select the
input you want to learn commands for,
then press the key to enter the
selection.
For example, if you are going to learn an
operation for a CD player, select CD/
SACD.
You can also select the TV ?/1 button.
3
Press the button you want to use for
the Learning function.
The USE MODE button turns off while a
valid button is pressed, then blinks slowly.
4
Point the remote control code receiver
section of the remote towards the
receiver/transmitter on the remote
control to be learned.
5
Press the appropriate button on the
remote control to be learned to send
the remote button code.
Lightly pressing the button once should be
sufficient.
If learning is completed successfully, the
USE MODE button slowly flashes twice
and the remote automatically exits the
learning mode.
When learning is not completed
successfully, the USE MODE button
flashes 4 times in quick succession and the
procedure returns to step 5.
If the memory of the remote is already full,
the USE MODE button flashes 8 times in
quick succession and the remote
automatically exits the learning mode.
Notes
• You can program at the most 80 keys for the
Learning function. In some cases, you may not be
able to program even if you have not programmed 80
buttons.
• In steps 2 and 3, the USE MODE button turns off
while a valid button is pressed.
• In step 3, if several buttons that can be used for
learning are pressed, only the last pressed button is
valid. The USE MODE button blinks slowly, then
lights when the valid button is selected.
• In step 5, if a button that can be used for learning is
pressed, the new button is selected and the learning
procedure returns to the beginning of step 5.
To cancel learning
Press USE MODE during any step. The remote
automatically exits the learning mode.
To clear the learned codes
Start again from step 1.
After step 3, press TV ?/1 for more than 2
seconds. The USE MODE button blinks twice
slowly and the learned code is cleared.
If TV ?/1 is pressed less than 2 seconds, the
learning procedure returns to the beginning of
step 5.
When a learned code is cleared, if the button was
previously programmed for another input, the
programmed code for that input can be used.
To use the learned input
Move the easy scroll key to select the learned
input, then press the key to enter the selection.
To use a command that has been
learned
Select a learned input, then press the learned
button for that input.
Learning the commands of
your components
N
X
m
M
.
>
-
x
P O
f F G
g
5-10 cm