Sony HT-SF2000 - Manual (Page 27)

27 GB
D:\Chin Meng's job\SONY-HA\HT-SF2000_R2\2000_data\3210806121\GB03CON_HT-SF2000-
CEL.fm masterpage: Right
Getting Star
ted
[HT-SF2000/HT-SS2000]
3-210-806-12 (2)
Press AMP MENU, then press
AUTO CAL.
You can also select “A.CAL YES” in the
A. CAL menu.
The following appears on the display.
A.CAL [5] t A.CAL [4] t A.CAL [3] t
A.CAL [2] t A.CAL [1]
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Note
You cannot measure the speaker height of the
surround speakers. Set this value using “SUR POS.”
parameters in the SYSTEM menu (page 36).
Tip
When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
– Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT
SELECTOR on the receiver.
– Change the volume level.
– Press AUTO CAL again.
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Performing Auto Calibration
Measurement for Display
Speaker existance TONE
Speaker gain, distance,
frequency response
T.S.P.
Sub woofer gain and distance WOOFER
1 2 3
4 6
7 8
0/10 ENTER
9
SYSTEM STANDBY
TV INPUT
SLEEP DMPORT
TV ?/1
AV ?/1
VIDEO 1 VIDEO 2 VIDEO 3 DVD
2CH A.F.D.
RETURN/EXIT MENU
MOVIE MUSIC
MEMORY DVD MENU
FM MODE CLEAR
TOOLS DISPLAY MUTING
TV VOL
MASTER VOL
AUTO CAL
D.TUNING
D.SKIP
AMP MENU
SAT TV SA-CD/CD TUNER
?/1
-
F
G g
f
5
>10/
AUTO CAL
Input
buttons
?/1
switch
MASTER
VOL +/–
MUTING
AMP MENU
Confirming/saving the
measurement results
Measurement
result Display Explanation
When the
measurement
process
completes
properly
SAVE Proceed to step
2.
When the
measurement
process fails
ERROR
XXXX See “When
error codes
appear” (page
28).
continued