Remaining recording time display, Remaining battery power display – Sharp VL AH 50 H User Manual

Page 25

Advertising
background image

V L - A H 5 0 H / p p . 0 1 6 - 0 1 8 ; 0 0 / 3 / 2 4 / 1 8 : 0 0

G. K . A s s o c i a t e s , To k y o

Basic Operations

Camera Recording

18

Remaining Recording Time
Display

When the VIEWCAM is recording in Camera
mode, about 10 minutes before the tape
reaches the end, an on-screen indicator
displays the approximate remaining recording
time.

Remaining Battery Power
Display

When using the VIEWCAM with the battery
pack as the power source, you can turn on and
off the remaining battery power display by
pressing the DISPLAY button.
If the battery power becomes very low, a
warning indicator will appear. Replace the
battery pack.

To turn off the remaining recording time display,
press the DISPLAY button.

Notes:
• The remaining recording time displays only show

the approximate time left. Also, they vary slightly
depending on the length of tape used. (This
function’s design is based on the P5-90 tape
standard.)

• If you turn off the remaining recording time

display, it will reappear after a short interval to
indicate the new time remaining.

• The remaining recording time display appears

5 seconds after pressing the REC START/
STOP button to begin recording.

10 min.–8 min.

8 min.–6 min.

6 min.–4 min.

4 min.–2 min.

2 min.–1 min.

T A P E
T A P E

T A P E
T A P E

T A P E

Approx. remaining

recording time

On-screen

indicator

(Red)

(Green)

(Green)

0 min.

(The tape has

reached the end.)

1 min.–0 min.

Warning indicator

DISPLAY button

DISPLAY button

Remaining battery
power display

Notes:
• Use the remaining battery power display only as

an approximate indication.

• The battery power display may change to either

a higher or lower level if you set the Power
switch to OFF and then back to CAMERA or
VCR.

• In cold environments, the red remaining battery

power display may appear sooner. The battery
pack, however, can be used until the warning
indicator appears. Replace the battery pack at
this time.

• Battery consumption may vary depending on the

condition of use.

• Use of the zoom function when the warning

indicator is displayed may cause the VIEWCAM
to suddenly lose power.

Advertising