Sharp SD-CX1H - Manual (Page 51)

51
CX1H_UK49-59.fm 00/12/17
Ad
v
a
nced Fe
atur
es
Ti
mer
a
nd S
le
e
p Oper
a
ti
o
n


Using the same timer setting
Once memorised, the timer setting can be used as follows.
Notes:

The timer setting will be cleared when the unit is unplugged or the power failure
occurs.

The timer playback is possible with a CD or MD even if the repeat, random, or pro-
grammed playback is set.

When performing timer playback or recording using another unit connected to the
AUX INPUT sockets, select "AUX" in step 11. At this time, only this stereo system
will be turned off automatically. (Another unit will not be turned off.)
To check the timer setting:
To change the timer setting:
Perform "Timer playback/Timer recording" from the beginning. (See pages 49 -50).
To cancel the timer playback/timer recording:

If the power is turned on whilst in the playback or recording stand-by mode, the
timer setting will be cancelled.

Proceed as follows to cancel without turning the power on.
1
Press the TIMER/DELETE button.
2
Within 10 seconds, press the REC LEVEL/CURSOR or button
to select "STANDBY".
If "STANDBY" is not displayed, the clock setting has been cleared.
In this case, reset the clock and the timer.
3
Within 10 seconds, press the ENTER button.
The timer setting is displayed in order.
The unit will enter the stand-by mode and then the playback or recording stand-by
mode automatically.
1 Whilst in the timer playback or timer recording stand-by mode, press the TIMER/
DELETE button.
2 Within 10 seconds, press the REC LEVEL/CURSOR or button to select
"TIMER CALL".
3 Press the ENTER button.

After the timer setting is displayed in order, the display will return to normal.
1 Press the TIMER/DELETE button.
2 Within 10 seconds, press the REC LEVEL/CURSOR or button to select
"CANCEL".
3 Press the ENTER button.
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)