Sharp UX-P400 - Manual (Page 38)

Sending a Fax by Automatic Dialling
36
1
If you are sending a fax, load the
document(s).
•
If desired, press to set the
resolution and/or contrast.
2
Press once. <REDIAL> appears in the display, followed by the last
number dialled. Make sure the number that appears is the number you
wish to dial.
3
If you are sending a fax, press . Dialling and transmission
begins.
If you are making a phone call, lift the handset. Dialling begins.
AUFLÖS./
EMPFANG
START/
SPEICHER
Redial
You can automatically redial the last number dialled. This procedure can be
used to send a fax or make a phone call.
Automatic redialling
If you use automatic dialling (including Direct Keypad Dialling) to send a fax
and the line is busy, the fax machine will automatically redial the number. The
fax machine will make three redial attempts at an interval of five minutes.
During this time, RECALLING will appear in the display, followed by a two-digit
number assigned to the fax job. You will not be able to dial any other locations
while the message appears.
♦
To stop automatic redialling, press .
♦
Under certain conditions (for example if a person answers the call on a
telephone), automatic redialling may stop before three redialling attempts
are made.
STOP
READY TO SEND