Smart Technologies SMARTBoard 480iv - Manual (Page 45)

6. Connect the cables to the projector.
7. Connect the power cable to a power outlet.
8. Press the Power button once on the remote control to confirm that the projector is operating
and that the lamp module is correctly installed, and then wait for the projector to turn on
completely.
9. Wait five minutes for the projector to warm up.
N
N O T E
You might need to adjust the projected image after you perform the previous procedures. For
more information, see the included installation instructions for the SMART Board 480iv and
680iv interactive whiteboard system ( smarttech.com/kb/153153 ) and Adjusting the image on
page 19.
Resetting the lamp timer
After you replace the lamp, you need to access the projector service menu and reset the lamp hour
counter. To prevent accidental errors, only a system administrator should perform this procedure.
N
N O T E
Always reset the Lamp Hours after you replace the lamp, because lamp service reminders are
based on the current hours of use.
g To reset the lamp timer
1. Using the remote control, press the following buttons quickly to access the service menu:
Down, Up, Up, Left, Up.
C
C A U T I O N
Do not adjust any settings in the service menu other than those listed in this guide. Changing
other settings can damage or affect the operation of your projector and may invalidate your
warranty.
C H A P T E R 5
Maintaining your interactive whiteboard system
35