Sony RDR-HXD995 - Manual (Page 147)

147
A
d
d
iti
o
n
a
l In
fo
rm
a
tio
n
, The recorder’s internal clock stopped due
to a power failure that lasted for more than
1 hour. Reset the clock (page 124).
, The channel was disabled after the timer
recording was set. See “Manual CH
Setting” on page 128.
, The programme position was hidden after
the timer recording was set. (See
“Disabling programme positions (Editor)”
on page 65.)
, Disconnect the mains lead from the mains,
and connect it again.
, The programme contains copy protection
signals that restrict copying.
, Another timer setting overlapped the timer
setting (page 59, 72).
, There is no DVD inside the recorder.
, There is not enough disc space for the
recording.
, The set top box receiver was turned off.
, The set top box controller was incorrectly
connected (page 18).
, The settings in “Setup” in the Menu bar
have been changed (page 64).
, The recorder was in the process of
dubbing.
, A scrambled channel is selected.
Recording does not stop immediately
after you press x REC STOP.
, It will take a few seconds for the recorder
to input disc data before recording can
stop.
On-screen instructions may appear after
pressing x REC STOP. In this case,
follow the on-screen instructions.
Recording does not stop after you press
x
.
, Press x REC STOP.
Timer recording is not complete or did
not start from the beginning.
, There was a power failure during
recording. If the power recovers when
there is a timer recording, the recorder
resumes recording.
Should the power failure continue for more
than 1 hour, reset the clock (page 124).
, Another timer setting overlapped the timer
setting (page 59, 72).
, Disc space was not sufficient.
, The VPS/PDC function is working.
Contents previously recorded were
erased.
, Data that is not playable on this recorder
but was recorded on a DVD with a PC will
be erased from the disc when the disc is
inserted.
The VPS/PDC function does not operate.
, Check that the clock and date are set
correctly.
, Check that the VPS/PDC time you set is
correct (there might be a mistake in the TV
programme guide). If the broadcast you
wanted to record did not send the correct
VPS/PDC information, the recorder will
not start recording.
, If the reception is poor, the VPS/PDC
signal might be altered and the recorder
might not start recording.
, The VPS/PDC function may not work if
the GUIDE Plus+ host channel setup is not
complete.
, The VPS/PDC function does not work
when the GUIDE Plus+ data is being
downloaded.
The recorder does not play any type of
disc (except HDD).
, The disc is upside down. Insert the disc
with the labelled side facing up.
, The disc is not correctly inserted.
, Moisture has condensed inside the
recorder. In this case, if the recorder is on,
leave it on (if it is off, leave it off) for about
an hour until the moisture evaporates.
, If the disc was recorded on another
recorder and was not finalised (page 46),
the recorder cannot play the disc.
The recorder does not start playback from
the beginning.
, Resume play was activated (page 74).
, You have inserted a DVD whose Title
menu or DVD menu automatically appears
on the TV screen when it is first inserted.
Use the menu to start playback.
Playback
,continued