Sanyo scp8300 - Manual (Page 125)

Setting the Flash
To activate the flash:
1. From camera mode, press (right softkey).
2. Highlight Flash and press .
3. Select one of the following options and press :
ᮣ Off to deactivate the flash.
ᮣ On This Shot to activate the flash for one shot.
ᮣ On Always to activate the flash for all pictures.
ᮣ Auto to activate the flash automatically.
Note: While the phone is open and in camera mode, press to
switch between flash modes.
Setting the Self-timer
To activate the Self-timer:
1. From camera mode, press (right softkey).
2. Highlight Self-timer and press .
3. Highlight the length of delay you want the timer to use
(10 seconds or 5 seconds) and press .
ᮣ To deactivate the Self-timer, highlight Off and press .
4. Press (left softkey) when you are ready to start the timer.
( appears on the lower left portion of the main LCD during
the Self-timer countdown.)
5. Get ready for the picture. (When the timer is down to three
seconds, the Self-timer icon will turn red and the phone will
begin to beep.)
To cancel the Self-timer after it has started:
ᮣ Press (right softkey).
Note: While the Self-timer is active, all keys are disabled except ,
, and (right softkey). Cancel
Cancel
Start
Options
Options
118
8300 Bell_EN_3b.qxd 05.10.25 16:45 Page 118