Spalding M682001 - Manual (Page 9)

12/06 ID# M682001
9
Correctly identify each pole section. Poles have an identification sticker that will be used as a
reference point in the next step.
2.
Bounce middle pole section (5) into top section (4) using a wood scrap as shown until the top pole no
longer moves toward the pole identification sticker on the middle pole.
3.
4
5
6
BOTTOM TOP
MIDDLE
IDENTIFICATION STICKER
5
4
Wood Scrap (not supplied)
Align dimple of top pole section (4) into trough of
middle pole section (5) as shown.
IMPORTANT!
HOLE
DIMPLE
middle pole
5”
(12.7 cm)
middle pole
1.5” (3.81 cm)
ID STICKER
Trough
THE IDENTIFICATION
STICKER IS LOCATED
5" FROM THE END OF
THE POLE. WHEN
PROPERLY POUNDED
TOGETHER, THE
POLE SECTIONS
SHOULD HAVE A 4-
1/2" MINIMUM
OVERLAP, LEAVING
1/2" BETWEEN THE
OVERLAPPING POLE
AND THE
IDENTIFICATION
STICKER.
CAUTION!