Sunbeam FP7710 - Manual (Page 3)

SAFETY PRECAUTIONS FOR YOUR
SUNBEAM FRYPAN.
• Use your frypan at least 200mm away from
walls and curtains.
• Do not immerse the control probe in water.
• If using a plastic spatula do not leave in
cooking vessel when hot.
• The frypan must only be used with the control
probe provided.
• Avoid using on metal surfaces e.g. sink,
hotplate.
• Remove the control probe before cleaning the
frypan.
• After cleaning the frypan ensure that the
control probe inlet area is completely dry
before using again.
S beam a e e afe c  ci he
de igig ad ma fac ig c  me d c ,
b i i e e ial ha he d c e al
e e ci e ca e he ig a elec ical a liace.
Li ed bel a e eca i  hich a e e e ial
f he afe e f a elec ical a liace:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• This appliance is not intended for use by young
children or infirm persons unless they have
been adequately supervised by a responsible
adult to ensure that they can use the appliance
safely.
• Young children should be supervised to ensure
that they do not play with the appliance.
• Never leave an appliance unattended while
in use.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
Sunbeam’s safety precautions
1