Sony CMT-HX3 - Manual (Page 24)

CMT-HX3.GB.3-095-514-11(1)
 GB
“Reading” is displayed for a long
time.
 It may take a while to finish reading the
USB device if there are many folders
or files on it. Thus, we recommend
following these guidelines.
 Total folders on USB device: 100 or
less
 Total files per folder: 100 or less
Erroneous display
 Send the music data to the USB device
again, as the data stored in the USB
device may have been corrupted.
Play does not start.
 Turn off the system, then reconnect the
USB device.
 Connect the USB device that this
system can play.
 Press  (or USB  on the unit)
 to start play.
Play does not start from the first
track.
 Set the play mode to Normal Play
mode.
Files cannot be played back.
 USB storage media formatted with file
systems other than FAT16 or FAT32
are unsupported.*
 If you use partitioned USB storage
media, only files on the first partition
can be played.
 Files that are encrypted or protected by
passwords, etc. cannot be played back.
* This system supports FAT16 and FAT32, but
some USB storage media may not support all
of these FAT. For details, see the operation
manual of each USB storage media or
contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or “ST”
flashes on the display.)
 Connect the antenna properly.
 Find a location and an orientation that
provide good reception, and then set
up the antenna again.
 Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
 Connect a commercially available
external antenna.
 Consult your nearest Sony dealer if the
supplied AM antenna has come off the
plastic stand.
 Turn off nearby electrical equipment.
To change the AM tuning interval
The AM tuning interval is factory-preset
to 9 kHz (or 10 kHz, for some areas; this
function is not available on the European
model).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn off the system.
2
While holding down TUNER/BAND
 , press /  .
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.