Sharp UX-P410 - Manual (Page 41)

Sending a Fax From Memory
39
2. Sendi
ng
Fa
x
e
s
Memory transmission
You can also send a fax through memory when sending to a single location.
This is convenient when sending to locations where the line is often busy, as it
saves you from waiting to pick up the original document and frees the feeder
for other operations.
6
When you are ready to begin transmission, press .
•
A Transaction Report is automatically printed out after Broadcasting is
completed. Check the "Note" column of the report to see if any of the
locations are marked "Busy" or have a communication error code. If so,
send the document to those locations again.
START/MEMORY
To send a fax through memory, load the document, press , and
then dial using one of the following methods:
♦
Press the number keys to enter the fax number and press .
♦
Press repeatedly to select an auto-dial number and press
.
♦
Press once to select the last number dialled and press .
START/MEMORY
START/MEMORY
START/MEMORY
START/MEMORY
If the memory becomes full...
If the memory becomes full while the document is being scanned, MEMORY
IS FULL and SEE MANUAL will alternately appear in the display.
♦
Press if you want to transmit the pages which have been
stored up to that point in memory. The remaining pages will be ejected from
the feeder. After transmission, the memory will be cleared and you can
transmit the remaining pages. You will also need to transmit the page which
was being scanned when the memory filled up.
♦
Press if you want to cancel the entire transmission.
START/MEMORY
STOP