Smeg SCA130P - Manual (Page 24)

Instructions for the User
26
13.2.2 Removing the glass panes
The glass in the door should always be kept thoroughly clean. For easier cleaning, it is possible to remove
the door (see “10.2 Removing the door”) and place it on a canvas; or open it and block the hinges in order
to extract the glass panes.
The glass panes of the door can be completely removed by following the instructions provided below.
Warning: before removing the glass panes, make sure that at least one of the door's hinges has been
locked in the open position as described in points “10.2 Removing the door”. This operation might have to
be repeated during the glass removal process if the door is accidentally freed.
Warning: replace the glass panes in the same order and in the same direction in which they were
removed. Finally, if the door was not removed, unlock the hinges and close it.
Warning: do not use the product without the glass inserted, otherwise the external surface of the door will
overheat.
Removing the internal glass:
• Remove the internal glass pane by pulling it towards you,
following the movement indicated by the arrows. Doing this
dislodges the 4 pins attached to the glass from their slots in
the oven door
Removing the middle glass panes:
• Pyrolytic models have two middle panes that are attached
together. Remove the middle panes by lifting them upwards
Cleaning:
• Now it is possible to clean the external glass and the panes
removed previously. Use absorbent kitchen roll paper. In the
case of stubborn dirt, wash with a damp sponge and neutral
detergent.
Replacing the glass:
• Replace the glass panes in the opposite order to which they
were removed.
• Reposition the internal glass pane, taking care to centre and
insert the 4 pins attached to the glass into their slots on the
oven door by applying a light pressure.