Sharp IM-DR400E - Manual (Page 46)

03/7/21 IM-DR400E_6.fm
46
IM-DR400E
IM-DR400E TINSE0562AWZZ
Ref
e
renc
es
-E
rr
o
r M
ess
a
g
es
-
Error Messages
A number or symbol appears in (*) position.
ERROR
MESSAGES
MEANING
BATT EMPTY " The battery has run down.
BLANK MD " Nothing is recorded.
(Replace the disc with a recorded disc.)
Can't COPY " You tried to record from a copy pro-
hibited MiniDisc.
(Record using the analogue cable.)
" You tried to record signals other than
music (such as data).
Can't EDIT " A track cannot be edited.
(Change the stop position of the track
and then edit it.)
Can't LOCK " You tried to remove the MD whilst re-
cording or editing.
Can't PLAY " You tried to play back a track that
cannot be played with this equip-
ment.
Can't READ
(*) " The disc data cannot be read be-
cause the disc is damaged.
(Reload the Minidisc or replace it with
another one.)
Can't REC " Recording cannot be performed cor-
rectly due to vibration or shock.
ERROR
MESSAGES
MEANING
Can'tSTAMP " Stamp function does not work.
(Check the number of tracks.)
Can'tWRITE " Cannot save the TOC information
correctly to a MiniDisc.
DEFECT! " The disc is scratched.
(If the recorded sound is not right, retry
recording or replace the disc with a re-
cordable one.)
DISC FULL " The disc is out of recording space.
Er-MD (**) " The microprocessor has reported a
system fault and the unit is out of or-
der.
(To have it repaired, go to the distributor
where you purchased the unit.)
HOLD " The unit is in the hold mode.
LOCKED " You removed a MiniDisc whilst re-
cording or editing.
(Turn off the power before removing the
MiniDisc.)
NO DISC " A disc has not been loaded.