Sanyo VM-6609 - Manual (Page 6)

PARTS NAMES
Rear Panel
1 AC input socket (AC INPUT)
Connect the AC power cord (supplied) securely to this
socket and to a wall outlet.
2 Video input terminals (VIDEO IN)
These terminals are used to input a video signal
source to this monitor.
Connect to the video output of a VCR or another
monitor (for loop through connection) or to a video
camera.
3 Video output terminals (VIDEO OUT)
These terminals are used to output a video signal
from this monitor.
Loop-through output of the video in BNC connector,
then connect to the video input of another monitor or
a VCR.
4 Termination Switch (HI/75 Ω (Lo))
Select the input impedance (HI/75
Ω
).
When using only one monitor, turn the termination
switch to the 75
Ω position. When using more than
one monitor, set all of the termination switch on the
monitors to the HI position. However, the last monitor
termination switch should be in the 75
Ω position for
proper line termination.
5 Sub-brightness control (SUB-BRI)
Turn to adjust picture brightness.
6 Vertical Size control (V-SIZE)
Turn to adjust picture vertical size of the picture.
7 Vertical hold control (V-HOLD)
If the picture is scrolling up or down on the screen,
turn this control until there is a single steady picture.
VM-6609 VM-6614
VM-6619
1 4 56
1 4 2 576
1 4 2 56
VM-6612
1 4 2 576
2
3
3
3
3
L8MAA/US (VMC-6609, 6612, 6615, 6620 GB) 2000. 11. 21
5