Sanyo 720P/1080P HDTVLCD DP32242 - Manual (Page 11)

11
En
g
lish
POWER CONNECTION/CHANNEL SEARCH
5 TV will begin the scanning "Progress".
If no channels found, TV will show below
message.
OK Skip
No channels found. Please cjeck if Antenna or
Cable signal is available. Select ‘Skip’ if Satellite
or cable box is used to recevie channels.
While doing scanning, pressing MENU or EXIT
key will pop up below message.
OK Enter Enter Move
Quit auto program?
Yes No
6 If "Skip" is selected, TV will display as below
message.
If you wish to perform a scan, select "Auto
program" on ANT/Cable setup menu on Setup
menu.
Setup
ANT in Cable
Auto program
Manual program
Signal meter
INITIAL SETUP
1
8VHWKH&85625ŸDQGźEXWWRQVWRKLJKOLJKW
preferred Language (English / Español / Français).
Press the OK button.
Language / Idioma / Langue Page 1/4
Move Enter OK
English
Español
Français
2
8VHWKH&85625ŸDQGźEXWWRQVWRKLJKOLJKW
preferred viewing mode Store Demonstration or
Home Use. Press the OK button.
3
8VHWKH&85625ŻDQGŹEXWWRQVWRVHWXS$17
Cable settings (Cable/Antenna/Not used). Press the
OK button.
ANT / Cable setup Page 3/4
Select “Not used” when viewing TV via Satellite recelver or Cable box. Note : Select “Cable” when viewing
via Cable DTA Box.
Antenna Not used Cable
ANTENNA Cable In
4 Use the CURSOR
ŸDQGź buttons to set auto
program Start or Skip. Press the OK button. Select
"Start"