Sea & Sea 860G - Manual (Page 6)

10
11
1
2
2
m
m
+
-2
1
2
2
m
m
+
-2
165 mm+-2
Formatting a brand new card is strongly memory
recommended for first use.
Getting Ready
Getting Ready
Attaching the Wrist Strap
Inserting or Removing a Memory Card
1. Power off the camera.
2. Open the Battery / Memory Card Cover.
3. Insert the memory card into the card slot and press it
down until a click sound happens. (
memory card again to get it out once a click sound happens.)
4. Close the Memory Card Cover.
Please press the
The image(s) can be stored either in built-in flash memory
or in memorycard. When the memory card is inserted, the
images willbe stored in the memory card rather than the
built-in flash memory.On the other hand, the images will be
stored in the built-in flashmemory when a memory card is
not inserted.
Basic Photography
3 2 1
1. Press down the POWER Button to turn on the camera.
3. Use TELE/WIDE Button to zoom in and zoom out.
4. Press the shutter button half way to do the focusing and then press the shutter button fully down to capture an image.
5. The LED Indicator starts blinking right after the Shutter Button is released. Once the LED Indicator stops blinking, you are
ready to take another shot.
Or you can press Playback Button ( ) to view the images or movie clips you just took.
2. Set the Mode button at Image Shooting Mode ( ) for still image, Image Stabilizing Helper ( ) for image stabilizing,
Movie Clip Mode ( ) for movie recording and Voice Recording Mode( ) for voice recording.
Blinking
6
4 1 2
5
100-0021
3 6M 2
14
ISH