Schneider Optics Web Embedded Server - Manual (Page 27)

Installing and Configuring the Module
840 USE 115 00 Version 1.0 17
2.2 Installing the Module
The Ethernet web embedded server module comes fully ready to be installed.
Installation consists of mounting the module on the backplane and connecting the
cable.
2.2.1 Are You Really Ready to Install? Check!
Have you reviewed the configuration and network guidelines on page 15? You
must meet those guidelines before installing the module. If you are planning to
change the default configuration, stop the controller before installing the Ethernet
web embedded server module.
Modicon also recommends that you test to be sure your Ethernet cabling is working
properly before connecting it to the Ethernet module. Some suppliers of testing
equipment are listed in Appendix D.
2.2.2 Mounting the Module on the Backplane
Mount the module at an angle onto the two hooks located near the top of the
backplane. Swing the module down to make an electrical connection with the
backplane I/O bus connector.
Tighten the screw at the bottom of the module to fasten it to the backplane. The
maximum tightening torque for this screw is 2-4 in-lbs (.23 - .45 Nm).
Figure 10 Mounting an Ethernet Module on the Backplane
I/O Bus
Connector
Module
Hooks