Sun Microsystems MEDIACENTER 2.1 - Manual (Page 143)

Chapter 10 Troubleshooting 10-5
WARNING: stream id 107 (ba@426,3,80@) xmit error: Q size 33
Cause: Low-level software has detected a transmission error.
Action required: None. Most often, higher level software can recover from such
an error. However, if you receive such messages continually or if such messages
are accompanied by degraded video output, contact your Sun service
representative.
NOTICE: ba0: qsize OK
Cause: This is a Sun MediaCenter driver diagnostic message.
Action required: None. It is useful to trained technical personnel, particularly if
it occurs in combination with other messages listed here.
NOTICE: ba3: qsize 9 above hiwat
Cause: This is a Sun MediaCenter driver diagnostic message.
Action required: None. It is useful to trained technical personnel, particularly if
it occurs in combination with other messages listed here.
10.2.2 MFS Error Messages
The mfs perror utility displays information about a specific MFS error number.
perror usage is as follows:
The single parameter is the error number returned by MFS when it attempts to
execute an MFS utility. For example, an attempt to use
mfs create to create a file
in the MFS may return the following:
Use mfs perror to obtain further information about the error:
mfs perror error_number
Can’t create title 4260348
server# mfs perror 4260348
mfs_bmap_alloc: Unable to allocate mfs data blocks: Insufficient space on disk