Sharp AN-PHCM20 XG-PH50X - Manual (Page 2)

INSTALLATION INSTRUCTIONS CEILING BRACKET AN-PHCM20
C A U T I O N
INSTALLATION OF THIS ADJUSTABLE CEILING MOUNTING
BRACKET SHOULD BE PERFORMED BY QUALIFIED SERVICE/
INSTALLATION
PERSONNEL FOLLOWING THE INSTALLATION INSTRUCTIONS
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE
IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT
OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
IMPORTANT! THE INSTALLER SHOULD READ THESE INSTRUCTIONS
THOROUGHLY
BEFORE BEGINNING THE INSTALLATION AND SHOULD MAKE
SURE THAT ALL THE WORK IS DONE IN COMPLIANCE WITH NEC AND ALL LOCAL
BUILDING AND SAFETY CODES. SAVE THIS BOOKLET AFTER THE INSTALLATION
IS
COMPLETED. THE ACCESSORIES REFERRED TO IN THESE INSTRUCTIONS
ARE
INTENDED FOR USE ONLY WITH COMPATIBLE SHARP PROJECTORS. SEE
SHARP PROJECTOR OWNER’S MANUAL OR SHARP DEALER TO DETERMINE
CAUTION: THE BRACKET MOUNTING SCREWS MUST GO DIRECTLY INTO THE
BEAMS. SHEETROCK, LATH AND PLASTER, WILL NOT PROVIDE A
SUFFICIENTLY SECURE SUPPORT.
CAUTION: TO REDUCE THE RISK OF PERSONAL INJURY, USE ONLY THE
COMPONENTS WHICH ARE INCLUDED IN THIS PACKAGE, OR SPECIFIED IN
THESE INSTRUCTIONS.
PARTS LIST FOR MODEL AN-PHCM20 CEILING BRACKET (SEE FIG. 1)
ITEM
DESCRIPTION QUANTITY
A.
PROJECTOR ATTACHMENT PLATE WHICH INCLUDES THE DUAL KNUCKLE
POSITIONING ASSEMBLY. 1
B. DUAL KNUCKLE POSITIONING ASSEMBLY DETAIL 1
C. LOCKING HEX NUT & WASHER 1
D. STEEL CEILING MOUNTING PLATE WITH SECURITY FITTING 1
E. PLASTIC TRIM FOR CEILING PLATE 1
F. 1/4 X 10 HEX HEAD LAG BOLTS 2-1/2” LONG 6
G. 1/4 X 10 HEX HEAD LAG BOLTS 3” LONG 6
H. 1/4” I.D. WASHERS FOR USE WITH LAG BOLTS 6
I. M4 X 12mm MOUNTING SCREWS FOR USE WITH ATTACHMENT PLATE 3
J. PLASTIC TRIM COLLAR 1
PAGE 2