Sharp AN-PHCM20 XG-PH50X - Manual (Page 7)

STEP 5 ATTACH THE POSITIONING ASSEMBLY TO THE CEILING PLATE
FIGURE 8
IF YOU INTEND TO RUN AUDIO OR VIDEO CABLES THROUGH THE CEILING PLATE
PROCEED WITH STEP 5.1 AND 5.2, OTHERWISE PROCEED TO STEP 5.3:
5.1
Cut opening in the ceiling plate trim cover as indicated on the label inside cover near
the center bushing.
5.2 Thread cables through the plastic trim cover.
5.3 Place the plastic trim cover in position over the ceiling plate and press the Velcro
tabs together.
5.4 After completing step #3, screw the longer shaft with the locking nut and washer
into the center threaded bushing on the ceiling plate as far as it will go. (See Fig. 8)
5.5 Tighten the locking nut against the ceiling plate using a 3/4” open end wrench or an adjustable
crescent wrench.
DO NOT RUN THE AC POWER CORD INSIDE THE PLASTIC TRIM COVER.
ALL WIRING MUST COMPLY WITH THE NEC AND ALL LOCAL BUILDING,
ELECTRIC, AND SAFETY CODES.
PAGE 7
INSTALLATION INSTRUCTIONS CEILING BRACKET AN-PHCM20
WASHER
LOCKING NUT
UPPER KNUCKLE