Sony RHT-G900 - Manual (Page 10)

10 GB
Connecting the FM wire
antenna (aerial)
Connect the FM wire antenna (aerial) to the
75
Ω COAXIAL jack.
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it
as horizontal as possible.
• If you have poor FM reception, use a 75-ohm coaxial
cable (not supplied) to connect the control unit to an
outdoor FM antenna (aerial) as shown below.
Bundling the cables
1
Connect the components to the stand.
For details, refer to pages 11 to 15.
2
Bundle the cables with the cord
manager to prevent them from tangling.
Stuff the cables into the cord manager as
shown in the illustration below.
Installing this stand
Install the stand after connecting all the
components to the stand.
Install the stand after allowing for a space of
more than 5 cm from the wall. This is to allow
for heat dissipation and to prevent the TV from
falling.
• Be careful not to pinch your fingers when setting up
the stand.
Notes
Tip
BD IN DVD IN SAT IN TV OUT
FM
ANTENNA
75
COAXIAL
HDMI
FM wire antenna (aerial)
(supplied)
75
Ω COAXIAL jack
FM
ANTENNA
75
COAXIAL
Rear of the stand
Outdoor FM antenna (aerial)
Note
More than
5 cm