Siemens C2-010 User Manual
Page 10
C2-010 / C2-010-I ADSL2+ Router User’s Guide
2.3.4 Hub or Switch to ADSL2+ Router Connection
Connect the ADSL2+ Router to an uplink port on an Ethernet hub or switch with a straight-through cable
as shown in the diagram below:
Figure2-5 Hub/Switch to ADSL2+ Router Connection
If you wish to reserve the uplink port on the switch or hub for another device, connect to any on the other
MDI-X ports (1x, 2x, etc.) with a crossed cable.
2.4 Power
on
1) To power on the ADSL2+ Router, please follow the steps as instructed: Insert the AC Power Adapter cord
into the power receptacle located on the rear panel of the ADSL2+ Router and plug the adapter into a
suitable nearby power source.
2)
You should see the Power LED indicator light up and remain lit. The Status LED should light solid
green and begin to blink after a few seconds.
2-4