Sharp XR-10S-L EN - Manual (Page 43)

41
Useful
Features
Adjusting the Projected Image
(“SCR - ADJ” menu)
Picture
Resize
Image Shift 0
0
SCR - ADJ PRJ - ADJ Help
Keystone
Auto Keystone
OSD Display
Background
Setup Guide
PRJ Mode
Language
Front
English
On
Logo
On
Off
Normal
SEL./ADJ. ENTER END
8
7
6
5
4
3
2
1
1 1 1 1 1 Setting the Resize Mode
• For details of the Resize mode, see pages 32
and 33.
• You can also press HRESIZE on the remote
control to set the resize mode. (See page 32.)
Note
2 2 2 2 2 Adjusting the Image
Position
You can move the projected image vertically.
Q button
• You cannot set this item when “Resize” is set
to “Normal”.
Note
O button
Menu operation n Page 37
* “Auto Keystone” can be operated only when using PG-MB66X or PG-MB56X
3 3 3 3 3 Keystone Correction
When the image is projected either from the top
or from the bottom towards the screen at an
angle, the image becomes distorted
trapezoidally. The function for correcting trap-
ezoidal distortion is called Keystone Correction.
For Manual Keystone Correction
Set “Auto Keystone” on the “SCR - ADJ”
menu to “Off”, select “Keystone”, and
then adjust with the slide bar.
For Auto Keystone Correction
Set “Auto Keystone” on the “SCR - ADJ”
menu to “On”.
O button Q button
Manual Correction
a When using PG-MB66X or PG-MB56X
a When using XG-MB50X-L, XR-11XC-L,
XR-10X-L or XR-10S-L
Select “Keystone” on the “SCR-ADJ”
menu and adjust with the slide bar.
• The Keystone Correction can be adjusted up
to an angle of approximately ±13 degrees
(when “Resize” is set to “Normal”).
Note
See page 31 for details of Keystone Correction.
XR-11XCL_EN_j 06.9.1, 0:27 PM 41