Sharp XR-10S-L EN - Manual (Page 51)

49
Appendix
Replace the filter holders.
• Align the tabs on the filter holders while
replacing them, and then press down on
the tabs to lock them in place.
4
Replacing the Dust Filters
• If the filters become too dirty to clean
effectively, purchase new ones
(PFILDA025WJZZ) from your nearest Sharp
Authorized Projector Dealer or Service Center.
After removing the filter holders (see
step 2 of “Cleaning the Dust Filters”),
remove the dust filters, then replace with
new ones.
• Pick the dust filters up with your fingers and lift
them out of the filter holders.
• With the reinforcement seal facing down, place
the dust filters underneath the tabs on the filter
holders.
Info
Reinforcement seal
• Be sure the filter holders are securely installed.
The power will not turn on unless it is correctly
installed.
Note
XR-11XCL_EN_l 06.9.1, 11:41 AM 49