Sony CMT-U1BT - Manual (Page 15)

1 GB
Basic Oper
ations
CMT-U1BT.GB.2-683-494-11(1)
4
Enter the passcode.
Passcode entry may be required depending
on the type of BLUETOOTH device.
For details about the operations of
the BLUETOOTH device, refer to the
operation manual supplied with your
BLUETOOTH device.
Enter the passcode at the system as follows:
“PIN?” and a countdown appear.
Press /  and /  to enter
the same passcode that was entered at
the BLUETOOTH device, and then press
ENTER  .
Once pairing is completed and the
connection is established, the system
display changes as follows:
“Connect”  Name of the BLUETOOTH
device
To cancel passcode entry partway
Press   .
Notes
• “Passcode” may be called “Passkey,” “PIN code,” “PIN
number” or “Password,” etc. depending on the device.
• This system only supports numerical passcodes up to
13 digits.
• The pairing standby status of the system is cancelled
after about 30 seconds. If pairing is not successful, redo
the procedure from step 1.
• While connected to a BLUETOOTH device, this
system cannot be detected and a connection cannot be
established from another BLUETOOTH device.
To erase all the pairing registration
information
1 Press BLUETOOTH   on the unit.
When the system is connected with
a BLUETOOTH device (when the
BLUETOOTH device name appears in
the system display), turn off the system
or change the function to cancel the
connection.
2 Press CLEAR

.
“Delete?” appears.
3 Press ENTER  .
“Complete!” appears and all the pairing
information is erased.
Note
In order to connect with a BLUETOOTH device after
performing this operation, you must enter the passcode
again.
Continued
