SentrySafe SPD 5.5.5 - Manual (Page 23)

Sample Sequencer 
Operation
To Program:
• Press the DISPLAY key to select desired function. To select desired POINT number
for the low and high alarms press the NEXT key.
• Press PROGRAM. The programming arrows light up and the current programmed
value is displayed.
• Starting at the right digit, pressing the key immediately above the up arrow
(DISPLAY) causes the digit to increment. Press repeatedly until the desired digit is
displayed.
• Each pressing of the key above the left arrow (NEXT) shifts the active digit one to
the left. The active digit may be incremented using the aforementioned up arrow
key.
• Each pressing of the key above the right arrow key (ALARM RESET) shifts the active
digit one to the right.
• Pressing the PROGRAM key again:
ƒ Turns the arrow lights off.
ƒ Saves the value in permanent memory.
ƒ Returns the Sample Sequencer to its normal display.
ƒ The newly programmed values are active on the next cycle. Press
START/RESET to restart the sequencer using the new values.
SENTRY Equipment Corp • P. O. Box 127 • Oconomowoc, WI 53066 • 262/567-7256 • FAX: 262/567-4523
Web: www.sentry-equip.com • e-mail: [email protected]
22