SentrySafe SPD 5.5.5 - Manual (Page 33)

Sample Sequencer 
Operation
Sample Nametag
Figure 10 shows the sample nametag which may be removed from the rear of the display
assembly by removing the front display bezel and four screws. The bezel may be snapped off by
lightly prying with a flat screw driver on one of the corners. The nametag slips into the pocket on
rear of the display. One may type the desired sample names slightly above the respective lines
and insert the nametag back into the display. Sample number one is on the top line. Two
nametags are shipped with each Sample Sequencer.
FIGURE 10 - Sample Nametag
SENTRY Equipment Corp • P. O. Box 127 • Oconomowoc, WI 53066 • 262/567-7256 • FAX: 262/567-4523
Web: www.sentry-equip.com • e-mail: [email protected]
32