Servis-Rhino SE10-4A - Manual (Page 93)

ASSEMBLY
SE10-4A/SE15-4A 03/09 Assembly Section 3-9
© 2009 Alamo Group Inc.
ASSEMBL
Y
FRONT AND REAR DEFLECTORS (Standard Equipment) CHAINGUARDS
(OPTIONAL EQUIPMENT)
Front and Rear rubber-fabric Deflectors are Standard Equipment and Front and Rear Chain
Guards are optional. One type of guard must be installed (and maintained in good repair)
except for agricultural purposes only in areas where persons, vehicles, livestock, or other
property will not be endangered by thrown objects and where such safety equipment would
prevent the mower's reasonable performance of its assigned agricultural task.
DEFLECTORS: Front and rear Deflectors (Standard Equipment) are recommended for the average user and
will provide superior protection from thrown objects with proper operation under normal conditions. Deflectors
must be maintained in good repair or replace after no more than two inches of wear off lower edge.
.Fasten the front Rubber Deflector (FIGURE 7) to
the Center Section and Wing Sections with bolts (1)
and locknuts (3) through the deflector bracket (#2).
Fasten the rear Rubber Deflector to the Center
Section and Wing Sections with bolts and locknuts.
Install each Deflector Panel (3,1) using,
the Deflector Strap (4,2) and three 1/2" x
1-1/4" Bolts (5) on the rear center and
four 1/2" x 1-1/4" Bolts on the rear wing,
Locknuts (7) and Washers (6).