Sears Diehard Portable Power 1150 28.71988 User Manual
Page 5
•
4
•
ASSEMBLY INSTRUCTIONS
5.
Remove all cord wraps and uncoil the cables prior to using the jump starter.
FEATURES
6.
jump Start On/Off switch
1.
Inverter/Compressor switch
2.
Digital Display
3.
Plastic lens cover
4.
(2) Light bulbs
5.
(2) 12V DC power outlets
6.
(2) 110V AC household
7.
power outlets.
USB port
8.
Power Switch (
9.
Light/Display)
Air compressor gauge
10.
Air compressor hose
11.
Air compressor accessory bag
12.
Air compressor ball inflation
13.
adapter
(2) Air compressor
14.
miscellaneous inflation adapters
ON/O
15.
FF inflator/deflator switch
High-flow inflator port
16.
Inflator/deflator hose end adapter
17.
High-flow deflator port
18.
Inflator/deflator hose
19.
(2) Cables with clamps
20.
(3) Inflator/deflator hose
21.
device adapters
Wall Charger (not shown)
22.
Charger Port
23.
Replaceable Battery (not shown)
24.
1
2
3
4
5
6
7
8
9
21
10
18
16 17
15
19
13 14 12
11
20
23
CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER
7.
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE
AND EvERY 30 DAYS TO KEEP THE JUMP STARTER’S INTERNAL BATTERY
FULLY CHARGED.
To check the internal battery’s charge status, toggle the Light/Display switch to the
7.1
DISPLAY position. The Digital Display will show the battery’s percent of charge. Charge
the internal battery if the display shows it is under 100%.
NOTE: The internal battery’s percent of charge is most accurate when the jump starter
has been disconnected from all devices and charging sources for a few hours.
Charging the Internal Battery using the Included Wall Charger.
7.2
To charge, plug the included wall charger into the charger port on the back of the
1.
jump starter.
Plug the wall charger into a 120V AC electrical wall outlet.
2.
While the jump starter is charging, the battery’s percent of charge will be displayed.
3.
When the internal battery is fully charged, the display will show 100. Complete
charging may take up to 72 hours. The jump starter is then ready to use.