Sea Eagle Boats 325FC - Manual (Page 4)

4
If the stem is not in the up position, turn the yellow stem
counterclockwise with your thumb to bring it in the up
position.
A41 Bellows Foot Pump
This pump is used for all our
products and is one of the best
on the market today. We firmly
recommend you always carry
your A-41 on board for safety.
Attach the hose to the valve on
the right side of the pump (as
shown in the picture) to inflate.
Use the Halkey-Roberts
adapter included with your
FoldCat
(placed in the repair
kit) to inflate this valve. Insert
the Halkey-Roberts valve adapter into the yellow hose of
the A-41 Bellows Foot Pump.
Push the adapter into the
Halkey-Roberts valve and turn
clockwise to lock it in position.
With our A41 foot pump, inflate each pontoon till you
cannot pump any more air into it. At this stage the foot
pump will become extremely hard and you will not be able
to press it any further. That means the pontoon has
reached its optimum pressure. Withdraw the adapter from
the valve and close the valve cap. Inflated FoldCat 375fc
should look like this.
Inflation with Electric Pumps
MB-100 High Pressure Electric
Pump
is specifically designed for
higher pressure inflatable boats
like our FoldCat 325fc & 375fc. It
has a set of alligator clips to hook
on to a 12 Volt car battery just like
a jump cable.
Make sure your pump is off and hook the red positive
alligator clip to the positive terminal of your battery. Hook
the negative clip to the negative terminal of your battery.
Adjust the pressure dial on the
MB-100 pump to 220 milibar, or
3.2 PSI as shown, and plug the
hose into the valve opening above
the dial for inflation.
The other
opening on the other side of the
pump is for deflation, which is not
required for our boats.
Please note, the MB-100 Pump
comes with a cluster of 8 adapters
that are numbered from 1 to 8.
(You do not have to use the
Halkey-Roberts valve adapter with
the MB-100 pump). These
numbers are written on the arms
of the cluster that hold each
adapter. You have to carefully
read these numbers on the arms
of the cluster.
Attach the other end of the hose to the adapter # 1 from
the cluster to inflate the FoldCats. Push the adapter in the
Halkey-Roberts valve and switch on the pump. It will
change gears during inflation and automatically stop once
the pontoons is fully inflated at 3.2 psi air pressure.
BST Super Turbo Electric Pump
The BST
features a two
stage pumping
system - a high
speed fan to
quickly inflate
your hull, and a
piston pump to
achieve the
desired
pressure our
FoldCats needs.
Not only is this
pump amazingly
fast, but it is portable as well. The high capacity battery
can inflate our FoldCats twice between charges. Includes
valve adapters, high capacity battery, 110 volt household
charger & 12 volt cigarette lighter adapter for car use.
The BST Super Turbo Electric Pump also has an
adjustable pressure dial and a cluster of 8 valve adapters
like our MB-100 Pump.
(You do not have to use the
Halkey-Roberts valve adapter with the BST pump). Adjust
the dial of the BST pump to 220 milibar, or 3.2 PSI. Insert
one end of the hose to the opening on the pump that has
an arrow pointing outward (for inflation).
The opening on
the other side of the pump with an arrow pointing inward is
for deflation, which is not required for our boats.
1
2
3
4
5
6 7
8
BOW