Star Micronics NX-2460C - Manual (Page 20)

14 Printer Setup
Re-installing the automatic sheet feeder
❏ Open the front cover of the printer.
❏ Carefully lower the automatic sheet feeder into the printer, making sure that
the two round tabs on either end of it enter into the corresponding slots
inside the printer. You should have the automatic sheet feeder angled
towards the front of the printer (at about the same angle that it was when
you pulled the feeder forward while detaching it).
❏ You should have the automatic sheet feeder angled towards the front of the
printer (at about the same angle that it was when you pulled the feeder
forward while detaching it).
❏ Lower the automatic feeder all the way down. When you do, it should
naturally slip into place, with the part that holds the paper angled slightly
towards the back of the printer.
❏ Close the front cover of the printer.