Samsung SCX-4720FN - Manual (Page 276)

B
U SING Y OUR M ACHINE ON A N ETWORK B.9
3 Press Enter.
The first available menu item, “TCP/IP,” appears on the
bottom line.
4 Press the scroll button ( or ) to display “DHCP” on the
bottom line and press Enter.
5 To assign the address from the BOOTP server, press Enter
when “BOOTP” displays on the bottom line.
Configuring IPX Frame Types
On IPX/SPX protocol networks (for example, Novell NetWare),
the format of the network communication frames must be
specified for the machine. In most cases, you can keep the
“Auto” default setting. However, you can manually set the frame
type format, if required.
• Off: The IPX/SPX protocol is disabled.
• Auto (default): Automatically senses and limits the frame
type to the first one detected.
• Enable 802.3: Limits the frame type to IPX over IEEE
802.3 frames. All others will be discarded.
• Ethernet II: Limits the frame type to IPX over Ethernet
Frames. All others will be discarded.
• Enable 802.2: Limits the frame type to IPX over IEEE
802.2 with IEEE 802.3 frames. All others will be discarded.
• Enable SNAP: Limits the frame type to IPX over SNAP
with IEEE 802.3 frames. All others will be discarded.
Take the following steps to change the frame type format:
1 Press Menu until you see “Network Setup” on the top line
of the display.
2 Press the scroll button ( or ) until “Config Network”
displays on the bottom line.
3 Press Enter to access the menu.
4 Press the scroll button ( or ) until “NetWare” displays on
the bottom line. Press Enter.
The first available menu item, “Off,” displays on the bottom
line.
5 Press the scroll button ( or ) until you see the desired
frame type and press Enter.