Sunrise Medical wheelchair Z-500 User Manual
Page 15
930578 Rev. B
I X . S e t - U p , A d j u s t m e n t & U s e
29
B. 90° FOOTBOARD
1. Height-Adjustment
a. Loosen the four clamp bolts (A) underneath the
footboard assembly.
b. Position footplate at desired height.
c. The adjustment on each side of the footrest
should be of equal height.
d. Tighten nuts.
2. Angle-Adjustment
a. Loosen the four nuts (B) underneath the footboard
assembly until the mounting tubes rotate freely.
b. Adjust mounting tube length, by sliding the
tubes inward or outward so it slides easily into
the sleeves.
c. Adjust the angle of the footboard.
d. Slide it forward or backward for
correct placement.
e. Tighten nuts.
C. ARTICULATING LEGREST (OPTIONAL)
1. Installation
To install or remove Articulating Legrest (ALR)
see instructions for Swing-away Footrest installa-
tion on page 28.
2. Adjustment
a. To raise legrest, lift to desired position.
Legrest will automatically lock in place.
b. To lower legrest, while seated in chair, first lift
slightly then lift release lever (A) up and lower
legrest to desired position. Legrest will automat-
ically lock in place.
I X . S e t - U p , A d j u s t m e n t & U s e
930578 Rev. B
28
CHECK-OUT
Be sure this chair performs to your chosen operational
settings. If it does not, turn the chair off immediately
and reprogram with the Quickie QTRONIX Programmer.
If you do not own a Quickie QTRONIX Programmer have
your supplier reprogram your wheelchair as needed. Or,
you can order a Quickie QTRONIX Programmer for your
own use, from your supplier.
NOTE– Repeat this procedure until the chair performs
to your specifications
When properly set-up, this chair will operate
smoothly. Check to see that all components
work properly. If you detect a problem, be sure
to correct it before use.
A. SWING-AWAY FOOTRESTS
1. Installation
a. Place swing-away pivot saddle (A) into the
receiver (B) on front frame tube with the
footrest facing outward from the frame.
b. Rotate the footrest inward until it locks into
place on locking bolt.
2. Removal
a. To remove footrest, push release latch (C) toward
the frame.
b. Rotate footrest outward, and lift.
3. Height-Adjustment
a. Loosen set screws (D).
b. Slide footrest extension up or down inside frame
tube to desired height.
c. Tighten set screws.
4. Footplate Angle-Adjustment
a. Loosen the retaining bolt (E) in the frame tube.
b. Reposition footplate to desired angle.
c. Tighten bolt.
A
B
C
A
B
Articulating Legrests
A
D
E