Sunrise Medical wheelchair Z-500 User Manual
Page 16
930578 Rev. B
I X . S e t - U p , A d j u s t m e n t & U s e
31
G. REMOTE JOYSTICK SWING-AWAY RETRACTABLE
MOUNT (OPTIONAL)
The remote joystick is mounted with a mechanism
which allows the control to be locked in a forward or
retracted position using magnets.
Adjustment
a. To retract joystick, push outward on the inside of
joystick.
b. Push joystick away from front of armrest until it
locks into retracted position.
c. To return to forward position, push joystick
forward until it locks into place.
H. SOLID BACK AND SEAT INSERT
1. Installation
a. Place the solid back hook clamps (A) on the
push handles.
b. Position solid seat on the top of front frame and
press down until the saddles (B) are secured on
the frame.
c. Insert the quick-release pins (C) through the
mounting hole on the hook clamps.
I. WHEEL LOCKS
Quickie wheelchairs are shipped with high-mount wheel
locks. Wheel locks are installed at Sunrise unless you
have requested otherwise.
Use a torque setting of 100 in./lbs when setting-up
wheel locks.
1. High-Mount Wheel Lock:
a. Loosen the screws on the top of each clamp. Do
not attempt to remove one screw at a time.
b. Slide assembly toward rear wheel until clamp (D)
embeds into tire to prevent wheel movement
when in locked position.
c. Adjust angle position.
d. Tighten screws.
I X . S e t - U p , A d j u s t m e n t & U s e
930578 Rev. B
30
D. ELEVATING LEGREST (OPTIONAL)
1. Installation
To install or remove Elevating Legrest (ELR) see
instructions for Swing-away Footrest installation
on page 28.
2. Adjustment
a. To raise legrest, lift to desired position. Legrest
will automatically lock in place.
b. To lower legrest, while seated in chair, lift
legrest slightly while pressing release lever (B)
down and lower legrest to desired position.
Legrest will automatically lock in place.
E. REMOTE JOYSTICK INSTALLATION
1. To Connect
a. Line up small cylindrical connector with its
receptacle on the rear of the joystick.
b. Push in firmly.
2. To disconnect
Pull back on the retaining ring (H) of the cylindrical
connector until it disconnects from the joystick box.
F. TO ADJUST THE HEIGHT OF THE REMOTE JOYSTICK
a. Remove the two pan-head screws (A), securing
the angle bracket mount (B).
b. Remove the Joystick from the mount by unfas-
tening the two screws (C) on the underside of
the mount.
c. Position angle bracket mount such that you
achieve the desired joystick height. Four posi-
tions are available by relocating the mount
either on the top or bottom of the mounting bar
(D) and/or by rotation of the angle
bracket mount.
Elevating Legrests
90º Elevating Legrests
Remote Joystick
B
B
A
C
B
D
B
C
A
D
H