Samsung CLX-3175FW - Manual (Page 78)

78 _Troubleshooting
Send Error
(POP3) There is a problem in
POP3. Configure the POP3
setting.
Send Error
(SMTP) There is a problem in
SMTP. Change to the available
server.
Send Error
(Wrong Config) There is a problem on
the network interface
card. Configure your network
interface card correctly.
[Stop Pressed] Stop/Clear has been
pressed during an
operation. Try again.
Toner Empty
T
The toner cartridge
has run out. The
machine stops
printing.
Press OK to toggle
the message to Stop
or Continue or Black
Only.
W Stop X
If the black
toner cartridge
is empty,
Black Only
message does
not appear.
You can select the
option among Stop,
Continue or Black Only
with the left/right arrow.
If you select Stop by
pressing OK on the
control panel, the
machine stops printing.
If you select Continue,
the machine keeps
printing, but the quality
cannot be guaranteed.
If you select Black Only,
the machine prints the
data in black. In this
case, the mono printing
feature is preset in the
printer properties.
When you copy, the
Black Start button will
be activated only with
this condition.
If you do not select any,
the machine will work as
Stop is selected.
Replace the toner
cartridge with a new one.
(See "Replacing the
toner cartridge" on
page 67.)
Toner Exhausted
T
The lifespan of the
toner cartridge which
the arrow indicates is
reached. This message appears
when the toner is
completely empty, and
your machine stops
printing. Replace the
corresponding toner
cartridge with a
Samsung-genuine
cartridge. (See
"Replacing the toner
cartridge" on page 67.)
Toner Low
T
The corresponding
toner cartridge is
almost empty. Take out the toner
cartridge and thoroughly
shake it. By doing this,
you can temporarily
reestablish printing
operations.
MESSAGE MEANING
SUGGESTED
SOLUTIONS
Transfer Belt
Error A problem has
occurred in the
transfer belt in the
machine. Turn the power switch
off and on. If the problem
persists, call for service.
Tray
Paper Empty There is no paper in
the tray. Load paper in the tray.
Tray
Paper Mismatch The paper size
specified in the printer
properties does not
match the paper you
are loading. Load the correct paper in
the tray.
MESSAGE MEANING
SUGGESTED
SOLUTIONS