Sanyo AVP-429 - Manual (Page 43)

Programming your Remote Control
Introduction
Your remote lets you control four devices with one easy-to-use, compact unit. After
installing batteries, you can program the remote to control your VCR or DVD, Cable or
Satellite Receivers, Amplifier or Tuner, and Auxiliary devices. To do so, follow the
instructions in Programming a Device. For best results, please read and follow all the
remaining instructions. Keep this guide for future reference.
A Quick Look at
Programming a Device
To control VCR or DVD, Cable or Satellite Receivers, Amplifier or Tuner, and Auxiliary
devices, follow these steps. Before proceeding, find the codes for the devices you
want to program in [
Manufacturer's Codes] and write them down or highlight them.
To program a DVD Player, portable DVD player, or mobile DVD player, use the
DVD key.
1. Turn on the device (for example, DVD player) and, if needed, load media (for
example, a DVD).
2. Press a device key ( VCR/DVD, CBL/ SAT, or AUX).
3. Press and hold SET until the red LED blinks twice; then release.
4. Enter the first five-digit code for your device. The LED blinks once as each digit is
entered. If the code is correct, the LED blinks twice.
If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.
5. Aim the remote at the device and press
Power. The device should turn off. If it
does not, repeat steps 3 to 5, trying each code for your brand until you find one
that works. If you cannot find a code that works, see Searching for Your Code.
6. Repeat steps 1 to 5 for the other devices you want to control. For future reference,
write down each working device code below:
AUX Code:
CBL Code:
CD Code:
DVD Code:
SAT Code:
TNR Code:
VCR Code:
7. Press SET to save and exit
Searching for your Code
If your device does not respond to the remote after trying all codes listed for your
brand, or if your brand is not listed, try searching for your code:
1. Press a device key once.
2. Press and hold
SET until the red LED blinks twice; then release.
3. Enter 9-9-1, then the device group number (0= Cable, 1= TV, 2= VCR, 3=
Audio). The LED blinks twice.
4. Aim the remote at the device and press Power. The remote sends IR codes
from its library to the selected device, starting with the most popular code first.
If the device responds, go to step
7.
5. If the device does not respond, press CH+. The remote will try the next code.
Continue until the device responds.
Press CH- to try the previous code.
6. To search for other device codes, repeat steps 1 to 5.
7. Press SET to save and exit.
42
Other Information
The universal remote control unit can t be programmed to control a TV with
other brand. It has been preset to control this TV set, and this preset is
unchangeable.