Recording, Processor operations, Clearing the programmed signal – Sony SDP-E300 User Manual

Page 4: Recording on a video tape

Advertising
background image

11

GB

Processor Operations

When you programme the recording signal

While holding down the

r

button on the processor’s

remote and press the record button on the other remote.

If you cannot successfully programme signals, check
the following:

• If the LEARN indicator does not light up at all, the

batteries are weak. Replace both batteries.

• If the LEARN indicator does not flash or light up in

Step 3 or 4, there is interference. Clear the signal as
described in “Clearing the programmed signal”
below and programme again from the beginning.

• The two remotes are placed too far apart. Make sure

they are only 2 inches apart.

• If you don’t proceed to the following steps within

about 1 minute during Steps 2 and 3, the remote
automatically exits learning mode. Start again from
Step 2.

• If the memory in the remote has become full, (If you

programme signals of Sony components, you can
store about 30 signals.) You can programme a new
signal on a previously programmed button, but the
new signal will replace the previously programmed
one.

Notes

• You cannot turn on programmed components by pressing

a SYSTEM CONTROL/FUNCTION button. You have to
turn on the component’s power switch.

• Do not programme remote signals of air conditioners or

other household appliances.

Clearing the programmed signal

To clear the programmed signals, do the following.
The button’s functions are reset to the factory-preset.

1

Press LEARN to turn on the LEARN indicator.

2

While holding down BACKGROUND, hold down
the button to be cleared until the LEARN
indicator turns off.

Recording

This processor makes it easy to record to and from the
components connected to the processor. You don’t
have to connect playback and recording components
directly: once you select a programme source on the
processor, you can record and edit as you normally
would using the controls on each component.

Before you begin, make sure you’ve connected all
components properly.

ç

: Audio signal flow

c

: Video signal flow

Recording on a video tape

You can record from a LD player using the processor.
You can also add audio from a variety of audio sources
when editing a video tape.* See your VCR or LD
player’s instruction manual if you need help.

* If you connect a stereo system, or an individual audio

component, to the LINE IN jacks as shown on page 6.

1

Press VIDEO 2 (if an LD player is connected to the

VIDEO 2 jacks) to select the programme source.

2

Set the component to be ready for playing.
For example, insert the laser disc you want to

record from into the LD player.

3

Insert a blank video tape into the VCR for

recording.

4

Start recording on the VCR and then start playing

the laser disc you want to record.

You can replace audio while copying a laser disc

At the point you want to start adding different sound,
press LINE (if an audio component system is connected
to the LINE IN jacks, be sure to select the proper source
beforehand) and start playback. The sound from the
selected component will be recorded over the original
audio.

To resume recording the sound of the laser disc, press
the VIDEO 2 function button.

Playback component

(programme source)

c

з

з

c

Recording
component
(VCR)

Function buttons

Advertising