SMC Networks 1000 - Manual (Page 35)

I
NSTALLING THE
S
WITCH
3-7
Connecting to a Power Source
To connect a device to a power source:
1. Insert the power cable plug directly into the receptacle located at
the back of the device.
Figure 3-4. Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line
cord. You must use a line cord set that has been approved for
the receptacle type in your country.
3. Check the front-panel LEDs as the device is powered on to be
sure the Power LED is lit. If not, check that the power cable is
correctly plugged in.
4. If you have a purchased Redundant Power Unit, connect it to the
device and to an AC power source now, following the
instructions included with the package.