Siemens MC55 - Manual (Page 244)

MC55 AT Command Set
10.1 AT+CGACT
s
m
obile
MC55_ATC_V01.05 Page 244 of 469 2/10/04
Confidential / Released
The write command is used to activate or deactivate the specified PDP context(s). After the command has com-
pleted, the MT remains in V.25ter command state. If any PDP context is already in the requested state, the state
for that context remains unchanged. If the MT is not GPRS attached when the activation form of the command
is executed, the MT first performs a GPRS attach and them attempts to activate the specified contexts. If no
<cid>
s are specified the activation/deactivation form of the command activates/deactivates all defined contexts.
If the MT is not able to activate a context because of a failed attach, command returns with "ERROR" or with
"+CME ERROR: unknown" after 385 seconds (timer T3310 expired).
If the MT is attached but is not able to activate a context for more than 160 seconds (timer T3380 expired), com-
mand returns with "ERROR" or with "+CME ERROR: unspecified GPRS error. In this case AT+CEER returns
"+CEER: 51,3,0".
Parameter Description
Indicates the state of PDP context activation.
0 detached
[1] attached
PDP Context Identifier is a numeric parameter which specifies a particular PDP context definition. The param-
eter is local to the TE-MT interface and is used in other PDP context-related commands.
1...2
Notes
•
ATH
will deactivate any PDP context.
• If the MT is in dedicated mode, write command returns with "+CME ERROR: operation temporary not
allowed".
• A maximum of 2 contexts can be activated at the same time, no matter on which interface. Trying to activate
more than 2 contexts will cause "+CME ERROR: operation temporary not allowed". Note that, depending on
the provider, the number of activated contexts may be further restricted. In such cases "+CME ERROR:
unspecified GPRS error" will be returned and
AT+CEER
returns "+CEER: 50,26,0".
Remember that contexts may be activated implicitly by using the
ATD*98#
or
ATD*99#
GPRS compatibility
commands without specifying a
<cid>
.
<state>
(num)
<cid>
(num)