Samson Sub120 - Manual (Page 11)

Connecting the SUB120
10
SPEAKER OUTPUTS
LEFT+ LEFT- RIGHT+ RIGHT-
SPEAKER IMPEDANCE 4-8 LINE IN AUX IN
SAMSON DESKTOP MONITOR SYSTEM STEREO 40W X2 MODEL:DA80 MADE IN CHINA
LINE OUT SUB OUT MONO
SERIAL NUMBER
RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE AVIS RISQUE DE CHOC ELECTRONIQUE NE PAS OUVRIR CAUTION FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE ATTENTION UTILISER UN FUSIBLE DE RECHANGE DE MÊME TYPE
RIGHT LEFT RIGHT LEFT RIGHT LEFT
INPUT
– +
INPUT
– + +
–
–
+
PHASE
OFF
AUTO ON POWER
PEAK
VOLUME
FROM EXTERNAL AMPLIFIER
SPEAKER OUTPUT
TO PASSIVE SATELLITE SPEAKERS
SWEEP Hz
PREAMP LEVEL INPUT OUTPUT 70
40 180
5
0 10
+ - L R - +
ON 0 ° 180 ° + - L R - +
R R
L L
SUB120 120 WATT 10" SUBWOOFER
The SUB120 can be connected to the DMS80’s by using the LINE OUTS located on the DMS80’s rear panel.
When using the DMS80’s LINE outputs you will utilize the SUB120 internal electronic crossover, which will allow
you to experiment and fine-tune your monitor system. Follow the diagram and instructions below to interface your
new subwoofer.
• Make the connections between your mixer and your DMS80 monitor system as described in the DMS80’s
users manual and make sure that you turn your mixer all the way down.
* Connect the RIGHT and LEFT LINE OUTPUTS located on the rear panel of the DMS80 to the RIGHT
and LEFT PREAMP INPUTS on the SUB120.
• Turn the SUB120’s Volume all the way off, and set the SWEEP control to 100Hz.
• Now run some audio, like music on a CD, through your mixer and raise the output to the DMS80 monitor
system to a comfortable listening level.
• Now, slowly raise the SUB120’s LEVEL control and adjust the low frequency output to your taste. You
can experiment by listening to the difference when adjusting the crossover point with the SWEEP control.
Also, listen as you adjust the balance between the SUB120 and the DMS satellite speakers by changing
the SUB120’s LEVEL control. Once you find the balance you like, the SUB120 will track the satellites
when you raise or lower your mixer’s output.
USING THE SUB120 WITH THE SAMSON DMS80 MONITOR SYSTEM
Using The DMS80’s LINE OUTs