Sony DAV-BC250 - Manual (Page 57)

O
th
e
r O
p
era
tions
57 GB
* Except for North American models.
2
Press and hold TV CH + while entering
the code for transmit time (see table
below) using the number buttons.
The transmit time from the remote is
selected.
If you successfully set the transmit time
code, the TV button flashes twice slowly. If
the setting is unsuccessful, the TV button
flashes five times quickly.
Operation
Point the remote to the direction of TV and
this system, then press SONY TV DIRECT
once.
While transmitting the code from the remote, the
TV button flashes.
Notes
• This function is only for the SONY TV series,
however, some TV products may also not work.
• If this function does not work, change the transmit
time. The transmit time varies depending on the TV.
• If distance between the TV and this system is too far,
this function may not work. Install the system near
the TV.
• Keep the remote pointed in the direction of the TV
and this system while the TV button is flashing.
You can use a VCR or other unit(s) connected to
the VIDEO/SAT jacks. Refer to the operation
manual supplied with the unit for further
information on the operation.
Press FUNCTION repeatedly until “VIDEO”
appears in the front panel display.
Each time you press FUNCTION, the mode of
the system changes in the following sequence.
When “ATTENUATE” is set to “ATT OFF.”
TUNER FM t TUNER AM t VIDEO t
DVD t TUNER FM t ...
When “ATTENUATE” is set to “ATT ON.”
TUNER FM t TUNER AM t SAT t
DVD t TUNER FM t …
For details on “ATTENUATE”, see 58 page.
By pressing Number TV’s input source
TV/VIDEO 0 No input source
(Default)
1 VIDEO1
2 VIDEO2
3 VIDEO3
4 VIDEO4
5 VIDEO5
6 VIDEO6
7* COMPONENT 1
INPUT
8* COMPONENT 2
INPUT
By pressing Number Transmit time
TV CH + 1 0.5 (Default)
2 1
3 1.5
4 2
5 2.5
6 3
7 3.5
8 4
Using the Video or Other
Unit
1 2 3
4 5
8
0
6
7
10
9
FUNCTION
continued