Sharp FO-6700 - Manual (Page 194)

Messages and Signals
192
RELAY REFUSED A relay request has been denied because your fax
number has not been entered in the relay
machine’s list of permitted numbers, an auto dial
number not programmed in the relay machine was
specified, or your fax number has not been
programmed in your machine.
REMOVE ORIGINAL(S) The original document is jammed. See the
following section, Clearing Paper Jams.
SIZE ERROR This message will be followed by one of the paper
sources in parentheses, and informs you that the
paper loaded in that source is not all the same
size (UPPER indicates the upper cassette, and
LOWER indicates the lower cassette).
REPLACE TONER The toner cartridge must be replaced.
RX DOCUMENT TRAY OFF The received document tray is not attached.
Attach it as explained in Connections in Chapter 1
(the tray must be attached for the fax machine to
operate properly.)
WAITING<MEMORY FULL> The memory has become full and scanning has
stopped during scanning of a multi-page
document. Scanning will automatically resume
when sufficient memory becomes free (for
example, after several pages are transmitted).
Audible signals
Continuous tone 3 seconds Indicates the end of transmission,
reception, or copying.
Intermittent tone
(3 beeps) 5 seconds
(1 second on, 1
second off) Indicates incomplete transmission,
reception, or copying.
Rapid intermittent
tone 35 seconds
(0.7 seconds on,
0.3 seconds off) Indicates that an extension phone
connected to the fax is off hook.
all-FO6700.book Page 192 Wednesday, August 30, 2000 1:17 PM